Sailor's Solutions LLC      
 
product<br>image
Click to Enlarge

WP010 12-10 Ga. Fork #10 Stud, Waterproof (pack of 12) Made in USA
Waterproof triple layer technology forms the best watertight seal!
$10.95

View Cart

Problem:
It's an undisputed fact that most electrical problems on boats are traceable to failed connections. Most heat shrink connectors use a stiff and relatively short nylon insulating jacket with internal adhesive. Nylon jackets are difficult to heat-shrink and burning your wire jacket is a common occurrence. An extra heat shrink tube on the outside usually helps but often times makes for a sloppy looking job that defies inspection.

Solution:
Now it's easy to get secure professional-looking results with these amazing waterproof wire crimp connectors! Our waterproof connectors are far superior to typical after-market crimp connectors available. These connectors crimp down strongly and have a nylon protective jacket covered by a soft long polyolefin shrink jacket with lots of internal waterproof adhesive. This crimp gives your wire a strong strain relief and a waterproof seal. Once you work with our connectors you won't be satisfied with any others. We guarantee it!

Features:

  • A triple layer of protection around a 99.9% copper tinned connector provides the industry's most rugged and environmentally secure design.
  • Color-coded nylon insulation provides excellent puncture resistance.
  • Adhesive lining blocks out water and adds superior tensile strength and strain relief, while the outer layer of extra long clear polyolefin shrinks down around the wire sheathing to allow a complete environmental and abrasion resistant seal.
  • Seamless 99.9% copper tube for maximum strength and conductivity.
  • Three protective insulating layers.
  • Nylon inner layer adds mechanical strength and impact resistance.
  • Aggressive proprietary adhesive seals out moisture and provides strain relief.
  • Outer layer of clear extra long polyolefin shrinks easily without burning your wire jacket excellent abrasion resistance while allowing high visibility for inspection of the connection.
  • Nylon layer is see-through and color-coded to insure proper installation.

All connector sizes are bulk packed in 12 packs to save you money. Truly a superior product at a breakthrough introductory price!

* Meets or exceeds all UL and CSA requirements

product<br>image
Wireless 12 Volt DC Remote Switch
Use the same technology that unlocks your car door to turn your deck lights on before you board from up to 75 Yards away - Makes boarding easier and safer!
$39.00
product<br>image
Signal Mate 3 NM LED Anchor Light
Compact and rugged Designed for many years of operation. Mounting bracket included Made in USA!
$189.95
product<br>image
Extra Large Soundproofing Kit - 48 tiles for wider 36'-42' boat engine compartment (1 inch X 1 foot X 1 foot tiles)
New and improved with fiberglass reinforced reflective surface!
You're going to love the quiet motoring!
$422.00
product<br>image
SCAD TM1 Tank Monitor Kit with Sensor.
Monitor holding tanks and water tanks with the touch of a button.
$169.00
product<br>image
SCAD PT90™ Propane Solenoid ShutOff Timer
Provides additional safety measure in case the user forgets to shut off the propane solenoid manually.
$99.00
product<br>image
SCAD Sensibulb™ LED Light - LED cabin light bulb replacement Made in USA!
Jan '09 Practical Sailor's Highest Lumen Output!The Brightest output LED system, pleasing color, broad focus, very low battery draw. Fits into vertical and horizontal fixtures! Zero radio interference!
$24.95
product<br>image
Medium Soundproofing Kit- 18 tiles typical 32'-36' boat engine compartment (1 inch X 1 foot X 1 foot tiles)
New and improved with fiberglass reinforced reflective surface!
You're going to love the quiet motoring!
$178.27
product<br>image
Lifeline AGM Deep Cycle Marine Battery
12 Volt (Size)24 (Capacity)80 Amp Hr

Charges deeper, faster and without maintenance!
Will not spill or leak!
$279.95

Go to top of page.